Woodworking
No blade swap fixes plywood tearout on its own — set the blade barely deeper than the sheet, score the cut line with a utility knife for one clean face, and press painter's tape hard into the fibers to get both faces clean.
@thefunnycarpenter · Instagram
Doors
Pull the top hinge pin, shim the door into the position you actually want, then bend the door-side hinge knuckles with a wrench until they line back up. Drop the pin in and the door holds its new position.
@thefunnycarpenter · Instagram
Carpentry
Use your hand as a pivot point so the blade enters where you aimed it instead of skating sideways and scarring the surface next to the cut.
@thefunnycarpenter · Instagram
Cabinetry
Thick superglue soaked into the blown-out particleboard and set with activator hardens the board enough to take a hinge screw again.
@thefunnycarpenter · Instagram
Trim
Prop the board on two identical blocks, then slide a third along the floor with a pencil on its top edge to trace the hump onto the board.
@thefunnycarpenter · Instagram
Cabinetry
A European cabinet hinge adjusts in three directions, so a door that rubs or sits low doesn't need rehanging. Set the side-to-side reveal first.
@thefunnycarpenter · Instagram