Align a Cabinet Door With Its Hinge Screws

The Problem

If you have a cabinet door that rubs its neighbor, sits low against the one beside it, or stands proud at the top, you don't need to rehang it. The hinge already adjusts in all three directions. Two of those adjustments are a single screw each and the third is the four screws holding the hinge to the cabinet.

The Techniques

Work them in this order. Side to side changes what the other two look like, so setting it first saves going round twice.

1. Side to side — the reveal

The screw on the hinge arm moves the door left and right. Turning it clockwise draws the door away from its neighbor, which is the fix for two doors rubbing where they meet.

Aim for an even 1/8 inch gap down the full length of the joint. Split the movement between the door's top and bottom hinges rather than taking it all out of one.

2. Height

Loosen all four screws holding the hinge to the cabinet side about a turn each, so the hinge can slide without coming loose. Lift or drop the door to line its top edge up with the one beside it, then snug the four screws back down.

Check the height with the door shut before you tighten fully. A door that lines up while held open can drop as the hinge takes the weight.

3. Depth — flush at the face

The rear screw on the hinge sets the door's depth in the frame, which is the adjustment for a door standing proud at the top. Back it off, push the door in until it sits flush with the frame, and re-snug.

Pro tip: Shut the door after every adjustment and look at the gap rather than the hinge.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques