Stop a Sink Cutout Dropping Into the Cabinet With a Batten

Screw a batten across the waste piece before you finish a worktop cutout, so the offcut can't drop into the cabinet below.

sink cutout falls through, cut a hob hole in a worktop, stop offcut dropping, cutting a kitchen countertop, support waste piece when cutting

beginner Tools: jigsaw, drill, screws Added Nov 7, 2026

The Problem

A sink or hob cutout is a closed shape, so the last few inches of the cut release a piece of worktop that has nothing holding it. That offcut is heavy, and it drops straight into the cabinet below — onto the carcass side, or onto the pipework if the plumbing is already in.

The waste piece also moves while you are still cutting. One that sags on the last corner pinches the blade and tears the laminate at the edge of the cut you are trying to keep clean.

The Technique

  1. Cut the straight runs of the opening first and leave the corners.
  2. Lay a length of batten across the waste piece, long enough to bridge the opening and land on solid worktop at both ends.
  3. Screw through the batten into the waste piece.
  4. Finish the corners. The offcut stays hanging on the batten instead of dropping.
  5. Lift the piece out by hand.
Pro tip: On a long opening use two battens rather than one in the middle, so neither end of the offcut can twist as the cut passes it and chip the laminate.
Safety note: Let the screwed-on batten take the weight rather than asking someone to hold the offcut from underneath. The blade comes through the underside of the worktop on the cut line, which is where that hand sits.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques