Cabinetry
Stop a Sink Cutout Dropping Into the Cabinet With a Batten
Screwing a batten across the waste piece of a sink or hob cutout so the offcut cannot drop into the cabinet or pinch the blade on the last corner.
@rectify_carpentry · Instagram
Where a run of cabinets leaves a void behind the toe kick — at a filler, at the end of a run, at a corner — there's nothing for the finish toe-kick trim to be nailed into. Drop an offset block into the gap first so the trim has a nailer across its whole length.
toe kick trim has nothing to nail to, gap behind cabinet toe kick, builder grade cabinets look better, cabinet filler toe kick, finish toe kick installation
The gap between the bottom of a cabinet box and the floor gets covered by a finish toe-kick trim, and that trim has to be fastened to something. Under the cabinet boxes themselves there's a ladder base or the box's own toe-kick to nail into.
Everywhere else there is nothing behind it. At a filler strip, at the end of a run, where a run turns a corner, or where the cabinets stop short of a wall, the toe kick keeps running but the structure behind it doesn't. You are left holding a length of finish trim against an open void, with nothing behind it for a brad to reach. Builder-grade installs solve this by ending the trim at the last cabinet, which is exactly the detail that reads as unfinished.
Fill the void with a nailer before the finish trim goes anywhere near it.
The result is a continuous toe kick with no gaps, no short returns, and nothing flexing when it gets kicked.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques