Get Cleaner Cuts with Your Multi-Tool by Bracing It on Your Other Hand

The Problem

An oscillating multi-tool blade has its teeth across the end and nothing to locate with — no point to drop into a mark, no fence to run against. Bring it down onto a line freehand and the teeth catch and run. The blade skates across the surface, and you end up with a scratch beside the cut you wanted and a start that is nowhere near your line.

Holding the tool tighter makes it worse, because the only thing stopping the blade moving is your grip.

The Technique

  1. Rest your free hand flat on the material beside the cut line, fingers clear of where the blade will travel.
  2. Set the body of the multi-tool on the back of that hand.
  3. Hold the blade parallel to the surface, just above the line, and start the tool.
  4. Pivot the tool down on your hand until the leading edge of the blade meets the line, and let it cut its way in. The hand is the pivot, so the blade comes down in an arc you control rather than sliding across the surface.
  5. Once the teeth are in past their own depth, bring the tool upright and cut normally.
Pro tip: A curved blade makes this considerably easier. The curve means only a short section of the edge is in contact as you pivot, so it bites in one place — where a straight blade is trying to engage its whole width at the moment it touches down.
Safety note: You are deliberately putting a hand next to a running blade, so the hand position is the whole safety question here. Keep it beside or behind the blade's line of travel and never in front of where the cut will run, and keep your fingers flat rather than hooked over an edge. A multi-tool will not take a finger off the way a circular saw will, but it cuts skin easily and the oscillation makes a ragged wound.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques