Woodworking
Chip-Free Plywood Crosscuts
Stacking blade depth, a scored line, and burnished painter's tape to crosscut plywood without veneer tearout.
2 takes from different creators
Clamp a stair gauge to the edge of the saw shoe and it rides the board's edge as a rip fence. It only reaches as far as the shoe is wide, so it's for narrow rips — but it needs nothing you wouldn't already have out for cutting stringers.
rip a board without a table saw, circular saw rip guide, lost my rip fence, cut a thin strip on site, narrow rip circular saw
If you don't have — or can't find — the janky rip fence that came with your circular saw, you don't have to make the cut by hand or take the piece to your table saw.
A stair gauge — the small clamping stop that fixes to a framing square when you're laying out stringers — does the same job as the factory fence for narrow rips.
The limit is geometric: the fence can only sit at the edge of the shoe, so the widest rip you can make is roughly the distance from the blade to the outside of the shoe. That's a few inches. For anything wider you're back to a straightedge.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques