Fit Baseboard Flat to a Humped Floor With Three Blocks

The Problem

A hump in the floor will prevent a piece of baseboard trim from sitting down flat. Pushed tight to the wall, the board rocks on the high spot and leaves a gap at each end.

The Technique

  1. Cut three identical blocks from one piece of stock. A quarter inch works as long as it clears the top of the hump.
  2. Prop the board on two of the blocks, one at each end, so it sits level and clear of the high spot.
  3. Run the third block along the floor with a pencil held against its top edge, drawing as you go. The line you get is the floor's profile, offset by the block's thickness.
  4. Take the board to the bench and cut close to the line with a circular saw, tipping the shoe so the cut is slightly off square.
  5. Finish down to the line with a belt sander, then soften the edge with 150 grit.

Why Three Identical Blocks

The two end blocks and the pencil block have to be the same thickness, because the line is only accurate if the gap it records is constant.

Pro tip: Tipping the saw a few degrees puts the back of the cut behind the line, so only the front edge touches the floor. That is less material to sand, and it sits tighter than a square cut, which can rock on the waste left behind it.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques