Cabinetry
Stop a Sink Cutout Dropping Into the Cabinet With a Batten
Screwing a batten across the waste piece of a sink or hob cutout so the offcut cannot drop into the cabinet or pinch the blade on the last corner.
@rectify_carpentry · Instagram
Technique: Rebuild a Blown-Out Screw Hole
Cabinet doors are often melamine-faced particleboard. A hinge plate screwed into this material has very little to hold onto. When a door hangs on one hinge, or gets caught hard once, the screws tear a crater out of the board and take the face with them.
Thick cyanoacrylate — superglue — soaks into particleboard and cures hard, so the repair is the board around the hole, not a plug in it. A cabinet door hinge hole is on a vertical face, though, and thin glue runs straight out of it.
He pulled each fixing to failure with a metal test rod. A factory screw into untouched melamine let go at 20 pounds; the same hinge plate on a repaired hole held to 30. Both numbers are his, from his own test on the same hinge plate, not a published rating.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques