Build a Wooden Gate That Doesn't Rot by Getting Water Off It Three Ways

The Problem

A wooden gate fails from the bottom up, and it fails at the joints. Both have the same cause: water that stops moving. A gate lives outdoors with no roof over it, gets rain on every face, and has more end grain exposed than almost anything else built from timber, and end grain takes up water far faster than a planed face does. No finish fixes a detail that holds water against the wood, however many coats go on it.

The Techniques

1. Don't house the boards in a trenched bottom rail

The tempting way to fix cladding boards into a gate is to plough a groove along the top of the bottom rail and stand the board ends in it. It looks tidy and it locates everything.

It also builds a gutter along the full width of the gate with the end grain of every board standing in it. Water collects in the trench, has nowhere to drain, and wicks straight up the boards. This is the failure that no amount of sealer prevents — thirty coats of end-grain sealer on a board standing in a puddle still ends up with wet feet.

2. Angle the top face of every rail

Every horizontal member is a shelf, and a flat shelf holds water. Cut a slope onto the top face of each rail so water runs off it.

Do it by angling the rail itself, not by adding a trim strip on top. A separate strip is one more joint for water to sit in and one more thing to come loose.

His test for any gate detail is a race: how fast does water get off this and onto the ground?

3. Join the frame with through tenons

Rails into stiles as through tenons, wedged from the far side — a joint that is mechanically locked rather than held by glue or a fastener that can corrode and work loose.

Pro tip: These three details are also what to look at when you're buying a gate rather than building one. Look at the bottom rail for a groove holding the board ends, run a hand across the top of the rails to feel whether they're flat or sloped, and look at the ends of the stiles for the end grain of a through tenon. Those tell you more about how long it will last than the species or the finish does.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques