Joinery
Drill Dowel Holes That Line Up -- With a Jig
Using a dowel jig's guide bushings and depth stop to drill square holes and transfer their positions to the matching piece.
@annabellejune_ · Instagram
Thirty years of gate building comes down to keeping water moving: never house the boards in a trenched bottom rail where they sit wet, angle the top of every rail so rain runs off instead of pooling, and join the frame with wedged through tenons rather than relying on fasteners.
gate bottom rail rotting, wooden gate falling apart, driveway gate construction, gate rail water pooling, through tenon gate frame, why gates rot at the bottom
A wooden gate fails from the bottom up, and it fails at the joints. Both have the same cause: water that stops moving. A gate lives outdoors with no roof over it, gets rain on every face, and has more end grain exposed than almost anything else built from timber, and end grain takes up water far faster than a planed face does. No finish fixes a detail that holds water against the wood, however many coats go on it.
The tempting way to fix cladding boards into a gate is to plough a groove along the top of the bottom rail and stand the board ends in it. It looks tidy and it locates everything.
It also builds a gutter along the full width of the gate with the end grain of every board standing in it. Water collects in the trench, has nowhere to drain, and wicks straight up the boards. This is the failure that no amount of sealer prevents — thirty coats of end-grain sealer on a board standing in a puddle still ends up with wet feet.
Every horizontal member is a shelf, and a flat shelf holds water. Cut a slope onto the top face of each rail so water runs off it.
Do it by angling the rail itself, not by adding a trim strip on top. A separate strip is one more joint for water to sit in and one more thing to come loose.
His test for any gate detail is a race: how fast does water get off this and onto the ground?
Rails into stiles as through tenons, wedged from the far side — a joint that is mechanically locked rather than held by glue or a fastener that can corrode and work loose.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques