Framing
Stiffen a Wobbly Stair Half-Wall by Bracing It to the Rim Below
Bracing a wobbly knee wall down to the rim board through a hidden hole in the floor.
@builtright_co · Instagram
Technique: Fit Spindles to Finished Treads
On a cut string staircase the spindles normally land in a housing cut into the tread, and the bullnose moulding that runs round the tread edge covers the fixings afterwards. That order only works on a new build, before the moulding goes on.
On a repair or rebuild, the treads are already down and the bullnose is finished, so cutting a housing now means taking off or damaging trim. The spindle still has to end up rock solid, because it is part of the guarding.
Each spindle gets a dowel in its base, and the tread gets a hole a millimetre larger than the dowel.
A dowel in a hole of the same diameter can only go in straight down, and a spindle that has to drop vertically into a tread will not clear the handrail above it. One millimetre of slop turns a vertical-only fit into one you can angle in, and the glue fills what is left.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques