Fit Stair Spindles to Finished Treads With a Glued Dowel

Glue a dowel into the base of each spindle and drill the tread hole a millimetre oversize, so the spindle tips in at an angle instead of needing a housing cut into a finished tread.

replace stair spindles without removing treads, cut string staircase spindles, balusters into finished treads, refurbished staircase handrail, spindle keeps moving

advanced Tools: drill, wood glue, brad nailer Added Nov 7, 2026

The Problem

On a cut string staircase the spindles normally land in a housing cut into the tread, and the bullnose moulding that runs round the tread edge covers the fixings afterwards. That order only works on a new build, before the moulding goes on.

On a repair or rebuild, the treads are already down and the bullnose is finished, so cutting a housing now means taking off or damaging trim. The spindle still has to end up rock solid, because it is part of the guarding.

The Technique

Each spindle gets a dowel in its base, and the tread gets a hole a millimetre larger than the dowel.

  1. Make a simple drilling jig that sits on the bottom of a spindle and puts the hole dead centre. The jig keeps 30-odd spindles identical.
  2. Drill the centre of each spindle base for a 24mm dowel.
  3. Cut dowels about 20mm long. Offcuts of 24mm mop stick handrail work, since that stock is already round and the right diameter.
  4. Glue a dowel into each spindle with wood glue, then countersink and run a screw into the dowel to hold it, or fire a couple of pins into it with a nail gun if the spindle is hardwood.
  5. Mark where each spindle lands on the tread and drill a 25mm hole there.
  6. Glue the hole and tip the spindle in at an angle, then bring it upright into position.
  7. Keep a wet rag to hand and wipe the squeeze-out as it appears.
  8. Pin the top of each spindle into the handrail as usual.

Why the Oversize Hole

A dowel in a hole of the same diameter can only go in straight down, and a spindle that has to drop vertically into a tread will not clear the handrail above it. One millimetre of slop turns a vertical-only fit into one you can angle in, and the glue fills what is left.

Safety note: Stair guarding is structural — it has to hold an adult falling against it, and in most places a staircase balustrade is covered by building regulations. The glued dowel is the only thing holding the spindle to the tread, so let it cure fully before anyone leans on it, and check what your local code requires before rebuilding a balustrade.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques