Untie a Pulled-Tight Ratchet Strap Knot With a Hammer

The Problem

Straps come out of the bag with knots in the loose tail, and some of them have been ratcheted down with the knot already in them. A knot that has had a load pulled through it is flattened against itself, with no slack anywhere to push a loop through. You cannot get a finger in to start it, and picking at it with a screwdriver frays the weave.

The Technique

  1. Lay the knot on something solid — a vice, a bench top, a scrap of timber on the ground.
  2. Tap it with a hammer, gently and square onto the flat of the knot rather than at the edges.
  3. Keep tapping until the knot swells back up.
  4. Once you can get a finger into it, untie it normally.

Each tap flexes the flattened webbing and breaks the friction holding one wrap against the next, which puts enough slack back in for a finger.

Pro tip: Once the load is strapped down and you are left with a long tail, double the tail back on itself and feed both the end and the fold into the ratchet spool, then take the handle a couple more clicks. The tail winds onto the spool as a loop and stops flapping. See securing a strap tail for two other ways to deal with a long tail.
Safety note: Check the webbing where you have been hitting it before you trust the strap with a load. A hammer on a hard edge can cut threads, and a strap with broken fibres across its width has lost its rating. Knots cost a strap strength even without the hammer, so don't put a strap away knotted.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques