Tool Maintenance
Keep a Chainsaw Chain From Loosening by Lifting the Bar Tip
Setting chain tension with the bar held where cutting will push it, so the chain stays tight once you start working.
@reelturftechs · Instagram
Keeping tools clean, rust-free, and adjusted.
10 techniques
10 shown
No techniques match. Try removing a filter or shortening the search.
Tool Maintenance
Setting chain tension with the bar held where cutting will push it, so the chain stays tight once you start working.
@reelturftechs · Instagram
Tool Maintenance
Permanently fixing a wheelbarrow tire that will not hold air, by replacing or filling it instead of patching it again.
@thespicynonna · Instagram
Tool Maintenance
Getting a load-tightened knot out of a strap by tapping it on something solid with a hammer until the webbing swells back up.
@realsheetmetalsamurai · Instagram
Tool Maintenance
Adding a soft copper spacer between a non-quick-release hole saw and its arbor so the two never gall together.
@addictedtotools · Instagram
Tool Maintenance
Checking the blade against a square for light, then adjusting the bevel stop's set screw so zero on the gauge means square to the base.
@woodbullyTV · YouTube
Tool Maintenance
Restoring a digging edge with a metal file at 30–45 degrees — enough bite to enter hard ground, deliberately short of razor sharp.
@grandpas_toolkit · Instagram
Carpentry
Checking a miter saw against an accurate framing square and re-squaring its fence and stops so 90 actually means 90.
2 takes from different creators
Painting
Getting more than one session out of a roller cover — washing and drying it for reuse, or keeping it loaded and sealed in a bag between coats.
3 takes from different creators
Tool Maintenance
A bucket-rim soaking rig plus the spread, pump, and comb routine.
@alecpaintsofficial · Instagram
Tiling
Restoring a slow-cutting diamond blade by grinding off its glazed surface layer.
@aesthetic.builder · Instagram
Or start from the whole library: browse all 609 techniques · search by tool, material, or problem