Untie a Pulled-Tight Ratchet Strap Knot With a Hammer

Lay the knot on something solid and tap it gently with a hammer. The blows flex the flattened webbing and put back enough slack to get a finger in.

knot in a ratchet strap, can't undo a tight strap knot, strap tail tangled, webbing knot too tight to pull, tie down strap knotted

beginner Tools: hammer, ratchet strap Added Nov 7, 2026

The Problem

Straps come out of the bag with knots in the loose tail, and some of them have been ratcheted down with the knot already in them. A knot that has had a load pulled through it is flattened against itself, with no slack anywhere to push a loop through. You cannot get a finger in to start it, and picking at it with a screwdriver frays the weave.

The Technique

  1. Lay the knot on something solid — a vice, a bench top, a scrap of timber on the ground.
  2. Tap it with a hammer, gently and square onto the flat of the knot rather than at the edges.
  3. Keep tapping until the knot swells back up.
  4. Once you can get a finger into it, untie it normally.

Each tap flexes the flattened webbing and breaks the friction holding one wrap against the next, which puts enough slack back in for a finger.

Pro tip: Once the load is strapped down and you are left with a long tail, double the tail back on itself and feed both the end and the fold into the ratchet spool, then take the handle a couple more clicks. The tail winds onto the spool as a loop and stops flapping. See securing a strap tail for two other ways to deal with a long tail.
Safety note: Check the webbing where you have been hitting it before you trust the strap with a load. A hammer on a hard edge can cut threads, and a strap with broken fibres across its width has lost its rating. Knots cost a strap strength even without the hammer, so don't put a strap away knotted.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques