Tool Maintenance
Untie a Pulled-Tight Ratchet Strap Knot With a Hammer
Getting a load-tightened knot out of a strap by tapping it on something solid with a hammer until the webbing swells back up.
@realsheetmetalsamurai · Instagram
Hold the tip of the bar up while you tighten the tension screw and then the bar nuts. That sets the bar where cutting pushes it, so the chain doesn't work loose.
chainsaw chain keeps getting loose, chain sagging off the bar, adjust chainsaw chain, chain came off the bar
If you tension a chain with the bar resting where it falls, it can work loose again as soon as you start cutting.
Cutting pushes the bar upward. When you set the tension with the bar sitting low, the bar rises as soon as you cut and the chain goes slack. Holding the tip up sets the bar where cutting would push it anyway.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques