Join Two Floors in a Doorway With a Transition Strip

The Problem

Two finished floors meeting in a doorway leave a raw edge and usually a height difference. Laminate against hardwood, vinyl against tile — you need something over the joint that bridges the step and hides the cut ends of both floors.

Transition strips come as a kit and look like one piece. There are two parts: a metal track that screws down, and a cap that snaps into the track and covers it along with the screws.

The Technique

  1. Measure the doorway opening.
  2. Cut the track and the cap to that length. An oscillating multi-tool cuts through both the metal track and the finished cap.
  3. Dry-fit the track and decide where it sits. Butt it against the edge of the higher floor so the cap lands just onto the lower one. Where the track sits is where the finished joint falls, so settle that before any screws go in.
  4. Screw the track down into the floor with the screws the kit supplies.
  5. Run a bead of construction adhesive along the track before you fit the cap.
  6. Snap the cap on: slide one edge into the track, then press the other side down until it clicks along its length.

Why the Adhesive

Without it, the cap spans the gap between its two snap points and flexes when you step on it — that flex is the hollow click underfoot. A thin bead under the cap takes the movement out. A little is plenty.

Pro tip: Don't hammer the cap down. Press it in with the heel of your hand along the whole length.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques