The Problem
If you are doweling two boards together by hand, the holes have to be square to the face, or the dowels fight each other going in. The second set has to land exactly where the first set did, or the joint will not close. Marking both pieces by eye and drilling freehand gets the holes close, not matched.
The Technique
The part names below are the ones on the jig in the video. A different jig will have the same two features under different names.
- Clamp the jig to the first piece and use its alignment function to set the hole on the center of the edge.
- Drill through the guide holes. The bushings hold the bit square the whole way down.
- Dry-fit a dowel into one of the holes you just drilled.
- Set what the jig calls its depth adjustment, which is really an offset stop. Drop the jig's locating hole over that dowel, slide the stop until it touches the edge of the board, and lock it. The jig now holds the distance from that dowel to the edge.
- Put the drilled piece on top of the piece you want to drill next, lined up the way the joint will go together.
- Drop the jig's tunnel over an existing dowel and bring the locked stop against the edge of the second piece.
- Drill. The hole lands at the same distance from the edge as the dowel it was set from, so the two sets line up.
- Glue the dowels and close the joint.
Pro tip: A plain drill guide only holds the bit square. This jig also carries the position: you are not measuring the second hole, you are copying it off a dowel sitting in the first. A layout mistake in the first piece gets copied to the second instead of compounding.