Keep a Chainsaw Chain From Loosening by Lifting the Bar Tip

The Problem

If you tension a chain with the bar resting where it falls, it can work loose again as soon as you start cutting.

The Technique

  1. Loosen both bar nuts just enough that the bar can move.
  2. Push up on the tip of the bar and hold it there.
  3. With the tip held up, turn the tension screw to tighten the chain.
  4. Keep holding the tip up while you tighten the bar nuts again.

Cutting pushes the bar upward. When you set the tension with the bar sitting low, the bar rises as soon as you cut and the chain goes slack. Holding the tip up sets the bar where cutting would push it anyway.

Pro tip: A common check, not from this video: the chain should sit snug against the underside of the bar but still pull around the bar easily by hand.
Safety note: Shut the engine off or take the battery out before you touch the chain, and wear gloves. The cutters are sharp even when the saw isn't running.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques