Stop Deck Stair Edges From Wearing Out With Aluminum Caps

The Problem

If your deck stairs look worse than the rest of the deck, look at the front edge of the treads. That edge takes the toe of every boot going up and the heel of every boot coming down, so it collects the nicks and gouges while the tread faces stay fine. A fresh coat of solid stain goes on with the rest of the deck and wears off that edge first.

The Technique

  1. Get painted aluminum angle, an inch and a half by two inches. The two-inch leg covers the thickness of the tread and the inch-and-a-half leg lies on the walking surface. Aluminum rather than steel, because it sits in the weather and will not rust.
  2. Cut it to the width of your treads. It comes in 48-inch lengths, which covers most residential stair widths in one piece.
  3. Run a solid bead of elastomeric sealant along the back of the angle, the kind that stays flexible and bonds to both metal and wood.
  4. Press it onto the nosing and hold it until it grabs. The sealant is the only thing holding it on — no screws or pins go through the angle.

The sealant holds the angle on. It also closes the joint, so water cannot get in behind the metal and sit against the end grain of the tread.

Pro tip: The creator is trying this on his own job for the first time, not repeating an established detail. The open question is the long bond line: metal and wood move at different rates in the weather, so a sealant that stays flexible matters more than one that grips hard.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques