Get Solid Deck Board Seams With a Block Beside the Joist

Don't butt two deck boards on a single joist, where each end gets about three-quarters of an inch to screw into. Screw a block alongside the joist and land the seam across both.

deck board ends splitting, butt joint deck boards, where to join deck boards, deck board ends not level

intermediate Tools: circular saw, impact driver, screws Added Nov 13, 2026

The Problem

If you butt two deck boards on one joist, each board end gets about three-quarters of an inch of joist to screw into.

The Technique

  1. Cut a block from joist stock.
  2. Screw it tight against the side of the joist where the seam will land, flush with the top.
  3. Land one board end on the joist and the other on the block, so each end gets the full thickness of a joist to screw into instead of half of it.

He rates the joint far stronger than a three-quarter-inch landing, and the two ends are easier to set level with each other.

Pro tip: You don't have to cut every board so the seam lands dead center on a joist. The block widens the landing, so your cuts don't need to be as exact.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques