Make Stucco Stick to Old Block With a Portland Slurry

Mix Portland cement with water to the consistency of paint and brush it on as a bonding agent for old block or stone. Plaster the first coat over it while the slurry is still wet.

stucco won't stick to block, render an old stone foundation, homemade bonding agent, parge a foundation wall, stucco finish textures, type s mortar for stucco

intermediate Tools: trowel, sponge, garden hose Added Nov 9, 2026

The Problem

If you are stuccoing an old block or stone foundation, a coat trowelled straight onto the masonry lets go in sheets. The old surface is dusty. It also pulls the water out of the mortar before the mortar can set. A bagged bonding agent fixes that. The trade used to mix its own out of Portland cement and water.

The Technique

  1. Plan the stucco to run below ground level rather than stopping at the soil line.
  2. Wet the wall down thoroughly with a hose. Dry masonry pulls the water straight out of the mortar.
  3. Mix Portland cement with water until it has the consistency of paint. That is the bonding agent.
  4. Mix the body coat separately: type S pre-blended mortar, which already has the sand, the lime and the Portland in it, plus water.
  5. Wet the wall again.
  6. Brush the Portland slurry onto the wall and plaster the first coat over the top of it straight away, while the slurry is still wet.
  7. Drag a brush over the fresh coat to leave scratch marks for the second coat to key into.
  8. Wait a couple of days if you can. Wet the wall, mix the same body coat again, and plaster the second coat on. Skip the bonding agent this time. Give this coat a light scratch as well.
  9. Put the finish on over that. How you apply it is the texture: thrown off the trowel it stays rough, a pass with a wet sponge brings it up smooth, and a soaked sponge flicked at the wall gives a splash finish. A broom does the same job as the sponge.
Pro tip: The slurry has to still be wet when the mortar goes over it, so the two cure together into one layer. If it dries first, you have painted the wall rather than bonded it.
Safety note: Portland cement and the lime in type S mortar are both caustic. Wet mortar held against skin causes chemical burns you may not feel while they are happening. Wear gloves and eye protection, and rinse splashes off rather than letting them dry.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques