Stop Mortar-Set Pavers Popping Loose by Slurrying the Back First

Before you set stone pavers in a mortar bed, coat the slab and the back of each paver with a slurry of water, cement and bonding agent. In the creator's pull test, a slurried paver was much harder to lift than a bare one.

pavers coming loose from concrete, stone paver popped up, laying pavers on concrete slab, bonding agent for pavers, wet laid pavers

intermediate Tools: trowel, bucket Added Nov 13, 2026

The Problem

If you're setting stone pavers in a mortar bed on a concrete slab, a paver set straight onto the mortar can come loose.

The Technique

  1. Mix a slurry of water, cement and a bonding agent.
  2. Coat the slab with the slurry before you lay the mortar on it.
  3. Spread the mortar bed.
  4. Coat the back of each paver with slurry and set it onto the bed.
  5. Tap it down until mortar squeezes out at the sides. The creator reads that squeeze-out as a sign the paver has suction on the bed.
Pro tip: The creator tested it on camera with the same mortar bed and about the same setting time for both. The paver set without slurry popped off easily. The slurried one was much harder to lift.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques