Aim the Brad Nail's Chisel Point Along the Panel, Not Across It
Brad nails have a chisel-shaped tip, and when the tip hits something hard it deflects in the direction the chisel faces. Orient the nailer so a deflected nail skips along the panel instead of blowing out the show face.
nail poked out the side, nails shooting out sideways, nails bend inside the wood, protect the good face when nailing
The Problem
Everyone who's run a brad nailer along a cabinet side or a trim edge has had a nail blow out the face of the panel — the fastener curls and erupts through the finished surface it was supposed to hide inside. The usual self-diagnosis is "I must have tilted the gun." Often the gun was fine. Brad nails have a chisel-ground tip, and when that tip glances off something hard inside the wood — dense grain, a knot, another fastener — it deflects in a predictable direction: the way the chisel faces.
The Technique
- Look at the strip of brads in your nailer and find which way the chisel points are ground. The nail will tend to skip in line with the chisel's wedge.
- When nailing near a panel face — attaching a cabinet back, running brads along an edge — rotate the nailer so the chisel is oriented along the panel, parallel to the face.
- Now if a nail hits something hard and deflects, it skips deeper into the panel or out the back — directions that don't matter — instead of out through the show face.
That's the whole tip: the nailer's rotation is a decision, not a whatever-is-comfortable grip.