Foil-Wrapped Buried Pipes
Wrapping plastic pipe in aluminum foil before a wall closes so pipe detectors can find it forever after.
Cap an Open Pipe on a Rough-In With Tape You Can Pull Off in Seconds
Technique: Tape Cap for a Rough-In
The Problem
An open pipe stub on a rough-in is a hole in the floor that everything on site eventually finds — dirt, sawdust, screws, gravel, the odd coffee cup. Test caps exist for this and you never have as many as you need. The fallback is tape over the opening, which works fine right up until you come back to make the connection: tape that has been stuck to a pipe for three weeks in the heat leaves adhesive and paper behind, and picking it off a fitting you're about to glue is a small miserable job repeated at every stub.
The Technique
The fix is to make the tape stick to itself and nothing else.
- Wrap one turn of tape around the pipe with the sticky side facing out. This is the step the whole trick depends on — this layer is a non-stick collar, and no adhesive ever touches the pipe.
- Lay a strip of tape across the opening, ending on the sticky collar so it grabs.
- Lay a second strip across the first at right angles, also landing on the collar.
Two crossed layers over the mouth of the pipe are stiff enough to shed dirt, debris and stones, and the whole assembly is held on by tape stuck to tape.
When you come back, it lifts off in one pull with nothing left behind — and because nothing was damaged getting it off, you can press the same cover straight back on if the pipe has to stay open a while longer.
Pro tip: The sticky-side-out collar is worth remembering on its own. Any time you want tape to hold something in place but not bond to the surface — a temporary cover on a finished floor, a bundle around a painted rail, a guard on a polished fitting — one reversed turn first turns any tape into a non-marking one.
Safety note: This is a debris cover for construction, not a cap. It will not hold pressure, it is not a substitute for a test cap on a system being pressure-tested, and it does not seal a drain line against sewer gas. Where the code or the test calls for a real cap, fit a real cap.
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.
DIYsolvr helps you find the best DIY videos. Browse all 526 techniques