Pipes & Fittings
Add a Shutoff Valve to a Copper Pipe Without Turning Off the Water
Adding a shutoff valve to a live copper water pipe with a clamp-on isolator that drills through the pipe behind its own seals.
@thewayeverythingworks · Instagram
Clean the pipe and fitting until shiny, deburr the cut end and flux both, then heat the fitting rather than the pipe until the solder draws in. Let the joint cool undisturbed; one knocked while hot will leak.
sweat copper pipe, soldered joint leaking, solder won't flow into fitting, pinhole leak copper, how to use flux
If you're sweating a copper joint, whether it leaks is decided by the cleaning and heating you do before the solder goes in.
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques