Add a Shutoff Valve to a Copper Pipe Without Turning Off the Water

A self-cutting isolator valve clamps around a live copper pipe and drills through its wall, with seals that keep the water in, so you can add a shutoff without draining the line.

install shutoff valve without draining, no shutoff valve under sink, isolate one fixture, self piercing valve copper, retrofit isolation valve

intermediate Tools: drill, adjustable wrench Added Nov 13, 2026

The Problem

If a fixture has no shutoff of its own, fitting one usually means turning off the water to the whole house and draining the line first.

The Technique

A self-cutting isolator valve goes onto the pipe while it's still full.

  1. Fit the two halves of the isolator body around the copper pipe and clamp them together.
  2. Tighten the body's four screws with a drill. The body now seals around the pipe.
  3. Attach the valve's drilling attachment to the isolator body and drill through the pipe wall. The seals inside the body keep the water in.
  4. Remove the drilling attachment and thread the brass valve into the body. Tighten it with an adjustable wrench.
  5. Fit the plastic housing over the valve and secure it to the body.
  6. Push the shutoff handle onto the valve stem and tighten it.
Safety note: Use one only on the pipe material and size it's made for, and only on water lines. Check that your local plumbing code accepts it before you rely on it as a permanent shutoff.

Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques