Solder a Copper Pipe Joint That Won't Leak

The Problem

If you're sweating a copper joint, whether it leaks is decided by the cleaning and heating you do before the solder goes in.

The Technique

  1. Clean the outside of the pipe end with emery cloth until it's shiny. Do this even on new pipe, which has a coating on it. Wrap the cloth around the pipe and work it around the circumference, not along the length.
  2. Deburr the inside of the cut end. Cutting leaves a sharp lip inside. Water tumbling over it will wear a pinhole in the joint.
  3. Clean the inside of the fitting with a fitting brush, or with emery cloth wrapped around your thumb, until it's shiny.
  4. Brush a light coat of flux over both the pipe end and the inside of the fitting. Solder won't bond to the copper without it.
  5. Push the pipe into the fitting and twist it a few times. The fit should be snug. Wipe the excess flux off the edge of the joint so the solder only sticks where it's meant to.
  6. Heat the fitting, not the pipe, moving the torch around it. Start on the thickest part of the fitting, and don't overheat it.
  7. When the copper starts to change color, pull the flame away and touch the solder to the joint. If it doesn't flow in, heat some more and try again. It takes very little solder.
  8. Wipe off the excess solder.
Pro tip: Set the joint down gently and let it cool before you move on. Right after soldering it's fragile, and a joint that gets dropped or knocked at this stage will leak.
Safety note: Use lead-free solder on any line that carries drinking water. When soldering in place, put a heat shield or a scrap of sheet metal between the flame and the framing behind the pipe.

Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques