The Problem
If you need to lift and re-level patio stones that weigh over 100 pounds each, a flat slab gives you nothing to grab.
The Technique
Build the pad
- Cut a piece of plywood for the pad and drill a 2-inch hole through it.
- Glue a skirt about 1/4 inch deep around the edge of the underside.
- Staple on a layer of plastic sheeting. The creator uses a garbage bag.
- Connect the shop vac hose to the 2-inch hole.
Build the lever
- Fix the pad to one end of a board.
- Slide the board under the axle of a two-wheel hand truck, so the axle works as the pivot and pushing down on the far end lifts the pad.
Lift
- Wheel the hand truck over to a stone and set the pad flat on it.
- Turn on the shop vac. The pad sucks down onto the stone. Tested on the floor, it held the creator's full 200-pound body weight without budging.
- Push down on the board to lift the stone and wheel it out of the way. Bring it back the same way to set it.
Safety note: The stone stays up only as long as the vacuum holds. If the shop vac cuts out or the seal breaks, it drops, so keep your feet out from under it and lift it no higher than you need to.