Mark Stitch Lines From a Pattern With a Two-Blade Utility Knife

The Problem

If you mark stitch lines from a paper or card pattern, a single-blade cut gives you an edge to trace but nothing to follow for the stitch line.

The Technique

Most styles of utility knife can be converted this way.

  1. Take the knife apart.
  2. Fit two blades side by side, with a spacer between them. The thicker the spacer, the wider the groove.
  3. Open up the blade slot at the front so both blades and the spacer pass through, either by stretching the opening a little or trimming it shorter. This is the fiddliest step.
  4. Reassemble the knife and cut the pattern as you normally would. The two blades take out a thin strip and leave a groove.
  5. Lay the pattern on the material and run a pen along the groove to mark the stitch line.
Safety note: Two exposed blades are harder to control than one. Trimming the knife body can also loosen its grip on them, so check the blades are held tight before you cut, and cut away from your hand.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques