If Your AC Refrigerant Line Insulation Is Crumbling, There's an Easy Fix

The foam sleeve on your outdoor AC's refrigerant line breaks down in sunlight and falls off, leaving bare copper that sweats and makes the system work harder. Replace it with split one-inch pipe insulation and UV-resistant tape for about ten dollars.

foam on ac pipe crumbling, insulation fell off air conditioner line, ac pipe bare outside, sweating refrigerant line, ac running up the bill

beginner Tools: utility knife Added Nov 7, 2026

The Problem

Two copper lines run between your house and the outdoor AC unit. The bigger one carries cold refrigerant back to the compressor. It comes wrapped in a foam sleeve. After that sleeve sits outside in the sun for years, it goes chalky, splits, and ends up hanging off in sections with bare copper showing between them.

Where the copper is bare, the refrigerant picks up heat on its way back, so the system does more work for the same cooling, and the cold pipe sweats and drips.

The Technique

  1. Look at the pipes where they leave the wall and enter the unit. If you don't see unbroken foam the whole way, with no copper showing, replace it.
  2. Pull the old foam off. Where it has gone brittle it comes away in your hand.
  3. Measure your line and the run before you buy. Cut the new pipe insulation to length — his was one-inch and cost about ten dollars. It is split down one side, so you wrap it around the pipe instead of threading it over the end.
  4. Close the seam and tape it, and tape each joint between lengths.

Use UV-resistant tape, not duct tape. Sunlight is what broke down the original sleeve, and ordinary tape will let go in one season.

While You're Out There

The condensate drain line blocks up with algae and slime, and the water then backs up wherever the indoor unit sits. Flush it every one to three months: pour vinegar down the line, let it sit about half an hour, then run water through. A funnel makes it a one-person job.

Turn a whole-house humidifier off for the summer rather than leaving it at its winter setting, and change the furnace filter every three months.

Pro tip: Buy the insulation a size over if you are unsure. One-inch foam on a 3/4-inch line still closes and tapes fine, where a sleeve that is too small will not seat and leaves the seam gaping.
Safety note: Kill the unit at its disconnect before you handle the lines. Only one of the two is cold — the other can be hot enough to burn while the system is running — and a condenser fan that starts while your hands are in the cabinet is the other reason to shut it off first.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques