Copy a Pipe or a Moulding Onto a Tile With a Contour Gauge Instead of Eyeballing It

The Problem

Tile has to meet things that aren't straight: a pipe coming up through the floor, a toilet flange, the moulded profile at the bottom of a door casing, a curved hearth. Measuring those by eye and cutting to the guess means a gap the grout can't hide, on a tile that cost real money and comes out of a box you bought exactly enough of.

The usual method is iterative — cut, offer it up, see where it fouls, cut again — and each iteration is either a fresh tile or a tile with less material left to correct with.

The Technique

A contour gauge is a bar holding a row of thin pins that slide independently. Press it against a shape and the pins push back individually, so the gauge takes the profile and keeps it.

  1. Press the gauge squarely onto the obstruction — around the pipe, into the casing profile, along the curve. Push it in until every pin has bottomed out against the shape.
  2. Lift it away without dragging it sideways. The pins hold their position by friction, so a knock resets part of the profile.
  3. Lay the gauge on the tile in the position the tile will sit, and draw along the pin ends.
  4. Cut to the line.

The same tool marks straight lines when the pins are pushed flat, so it doubles as a short straightedge for the ordinary cuts on the same job.

Pro tip: Trace the profile a couple of millimetres outside the pin line where the cut edge will be covered — by an escutcheon plate at a pipe, by the casing itself at a door. Fitting tight to a traced line looks like precision and leaves the tile no room to move; tile needs an expansion gap at every fixed obstruction, and a cut edge that will be hidden is the cheapest place to give it one.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques