The Problem
Tile has to meet things that aren't straight: a pipe coming up through the floor, a toilet flange, the moulded profile at the bottom of a door casing, a curved hearth. Measuring those by eye and cutting to the guess means a gap the grout can't hide, on a tile that cost real money and comes out of a box you bought exactly enough of.
The usual method is iterative — cut, offer it up, see where it fouls, cut again — and each iteration is either a fresh tile or a tile with less material left to correct with.
The Technique
A contour gauge is a bar holding a row of thin pins that slide independently. Press it against a shape and the pins push back individually, so the gauge takes the profile and keeps it.
- Press the gauge squarely onto the obstruction — around the pipe, into the casing profile, along the curve. Push it in until every pin has bottomed out against the shape.
- Lift it away without dragging it sideways. The pins hold their position by friction, so a knock resets part of the profile.
- Lay the gauge on the tile in the position the tile will sit, and draw along the pin ends.
- Cut to the line.
The same tool marks straight lines when the pins are pushed flat, so it doubles as a short straightedge for the ordinary cuts on the same job.
Pro tip: Trace the profile a couple of millimetres outside the pin line where the cut edge will be covered — by an escutcheon plate at a pipe, by the casing itself at a door. Fitting tight to a traced line looks like precision and leaves the tile no room to move; tile needs an expansion gap at every fixed obstruction, and a cut edge that will be hidden is the cheapest place to give it one.