Get Clean PVC Joints by Decanting Half the Primer

The Problem

If your PVC joints come out looking like purple paint got involved, the fix might be at the can rather than in your technique. A new can of primer is full to the neck, so the dauber comes out loaded and drips on the way to the pipe.

The Technique

  1. Decant about half the can of primer before you start.
  2. With the level down, jiggle the dauber against the inside of the can before you lift it out. That sheds the excess while leaving plenty for a full prime.
  3. Prime the pipe as far as the fitting's socket is deep and no further. The fitting in the video had a three-quarter-inch socket, so measure your own rather than using that number. Take the primer all the way around the pipe: a stripe left unprimed is a weak joint.
  4. Move to the cement, and do not jiggle this one. Twist the dauber against the rim of the can instead to take the excess off.
  5. Apply the cement, push the joint home with a quarter turn, and wipe the squeeze-out as you go.
Pro tip: Primer softens the PVC so the cement can fuse the two surfaces. A joint that was primed thinly can look identical to a good one and fail later.
Safety note: PVC primer and cement are both flammable. The fumes build up in a crawlspace or a closed bathroom, so ventilate, wear gloves and keep both cans away from any pilot light. Dry-fit the joint first: the cement grabs in seconds and leaves no second attempt at alignment.

Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques