Clean the A/C Evaporator Sensor
Wiping the dust off a sensor that reports the evaporator as colder than it is, making the computer throttle the compressor.
Turn a Ratchet Into an Adjustable-Angle Pry Bar
A pry-bar adapter snaps onto a ratchet or breaker bar like a socket — the ratchet head's swivel then lets you set the prying angle to fit spots in an engine bay where a fixed bar can't get position.
pry in a tight spot, no leverage under the hood, socket wrench pry attachment, move a stuck engine part
The Problem
Prying in an engine bay is a geometry problem. There's usually a spot to pry against and a part that needs persuading — but a fixed pry bar has one bend, and if that bend doesn't match the clearance available, you end up pushing at a bad angle from a worse position.
The Technique
Pry-bar adapters are sold as sets of socket-drive attachments — a prying tip with a square drive hole in it:
- Snap the adapter onto your ratchet or breaker bar like any socket.
- Set the head angle so the tip reaches the pry point while the handle sits where you can actually pull.
- Pry. The drive engagement holds the tip's orientation, and the bar's length is whatever your ratchet or breaker bar gives you.
One adapter effectively becomes a whole rack of differently-bent pry bars, because the angle comes from the tool head instead of the forging.
Pro tip: Use a breaker bar rather than a fine-tooth ratchet when the pry needs real force — a breaker bar's pivot head is solid, while a hard shock load on a ratchet head spends its life savings on the pawl mechanism.
DIYsolvr helps you find the best DIY videos. Browse all 526 techniques