Tie the Falconer's Knot — a Secure Hitch You Tie With One Hand

A quick-release hitch built for the moments when your other hand is holding the load: loop, pinch, scoop a bight through with a thumbs-up motion, and it locks tight — pull the tag end and the whole thing falls open.

quick release knot, easy to untie knot, hitching a horse

beginner Added Jul 22, 2026

The Problem

Half the time you need to tie something off, your other hand is busy — steadying the ladder, holding the thing you're about to secure, gripping a dog's leash. Most hitches want two hands and your full attention, so the load gets balanced on a knee while you fumble, or the rope gets a lazy wrap that lets go later.

The Technique

Falconers developed this hitch because their other hand permanently held a bird. It ties one-handed, holds hard, and releases with a single pull.

  1. Pass the rope around the rail or post with your free hand, so the tag end hangs on your side.
  2. Make a thumbs-up with that hand, and pinch the tag end between your first two fingers.
  3. Keeping the thumb up, scoop the standing line over the thumb — the thumbs-up motion builds a loop around your thumb as your fingers hold the tag.
  4. Pivot your two fingers away from you and pull the bight of tag end they're pinching through the thumb loop.
  5. Slip the loop off your thumb and pull the bight snug. Sliding the knot up against the rail sets it — pulling on the main line only tightens it.
  6. To release, pull the tag end. The bight pops free and the whole hitch falls open.

The falconer's tempo is the point: loop, pinch, scoop, through — a couple of seconds, one hand, and the load never leaves your other arm.

Pro tip: Because it's a slipped hitch, don't trust it where the tag end can snag on something and self-release — for temporary tethers and hold-this-while-I-work moments it's ideal, for overnight or safety-critical loads tie something permanent.

DIYsolvr helps you find the best DIY videos. Browse all 526 techniques