Tension a Clothesline or Guy Line After It's Tied With a Taut-Line Hitch

The taut-line hitch slides along the standing part of its own rope, so you can tie it with slack in the line and take the slack out afterwards — then move it again when the rope stretches.

adjustable knot for a clothesline, tighten a tarp after tying it, knot that slides and holds, guy line knot for a tent, rope went slack overnight, tie down a kayak on a truck

beginner Added Nov 1, 2026

The Problem

Most knots commit you to the length you tie them at. When you pull a clothesline between two trees and finish it off, you keep whatever sag was in it: tightening it means untying and starting again with the rope pulled harder, and single-handed that needs both hands on the tension and both hands on the knot.

Rope also stretches. A tarp guy line tensioned at dusk is slack by morning, and slack line flaps and chafes through at the grommet.

The Technique

The taut-line hitch grips the standing part of its own rope under load and slides along it when the load comes off, which makes the knot the tensioner. Tie it loose, then slide it to tighten.

Working end means the end you're tying with; standing part means the length running back to the anchor.

  1. Pass the working end around the far anchor — a tree, a stake, a roof rack — and bring it back alongside the standing part.
  2. Cross the working end under the standing part, then wrap it back over, toward the anchor. Do that a second time, so you have two turns sitting side by side.
  3. Take the working end past both turns, back toward yourself, and make one more turn around the standing part — this one on the near side of the pair, outside them.
  4. Tuck the working end down through the loop that last turn formed, and pull it up snug.
  5. Dress it: push the three turns tight against each other and pull the working end so the coils bed down.

To tension the line, hold the standing part and slide the whole knot away from the anchor. To slacken it, slide it back. Under load it stays put.

Pro tip: This is the knot on the guy lines of any tent that came with plastic tensioner sliders. The hitch does the same job, so you can carry on with a snapped slider or leave the sliders at home.
Safety note: The taut-line hitch holds by friction against its own standing part, which makes it rope-dependent. On slick line — new polypropylene, thin dyneema, anything with a glazed sheath — it can creep under steady load. Test it with a hard pull before you trust it, and don't use it where creep would drop something on someone.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques