Fixtures
Mark Vanity Cutouts by Painting the Pipe Ends — Then Finish the Hole Saw From Inside
Painting pipe ends to print exact cutout locations on a cabinet back.
@cnb_renovations · Instagram
Corners are almost never a true 90 degrees — usually because of drywall mud buildup or framing tolerance — so measuring straight from the corner to your plumbing centerlines puts the holes in the wrong place. Find the actual gap first, shift your reference line by that amount, then measure the plumbing holes from the corrected line.
corner vanity wont fit, cabinet plumbing holes wrong place, out of square corner cabinet, corner cabinet install measuring, vanity cabinet gap at wall
Measuring straight off the inside corner to mark plumbing centerlines assumes the corner is a true 90 degrees. It almost never is — drywall mud buildup or ordinary framing tolerance leaves most corners a few sixteenths of an inch acute or obtuse. Drill the holes off that assumption and the cabinet goes in with the plumbing lined up wrong, because the cabinet itself won't sit flush against a corner that isn't square.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques