Stop Wood Glue Clogging Its Nozzle With a Squeeze Bottle

The Problem

A factory wood glue bottle has a nozzle you push down to close. Even when you remember to close it, a bead of glue stays sitting above the seal. Wiping it off each time keeps the bottle working. Left alone, the bead cures into a ring that the next squeeze has to push through, which leaves more glue on top than before.

After a few rounds the top is welded shut, and the nozzle is molded into the bottle, so there is nothing to take apart to clear it.

The Technique

Pour the glue into a plastic condiment squeeze bottle — the flip-top kind a diner keeps ketchup in.

The flip top closes onto a flat face rather than a nozzle, so there is no standing bead to cure. The whole cap unscrews as well, so if glue does set up around the opening you take it off and clean it instead of throwing out a half-full bottle.

Keep the original glue bottle as a refill reservoir, and label the decanted one — ordinary yellow wood glue is PVA, and cured PVA looks identical to cured polyurethane glue in a clear bottle while behaving nothing like it.

Pro tip: Wood glue near the end of a bottle has usually lost some water and gone stringy. With the cap off you can stir in a few drops of water to bring it back; through a factory nozzle there is no way to reach it.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques