Unload a Trailer of Garden Waste in One Pull With a Strap

The Problem

If you're unloading a trailer of garden waste alone at the dump, forking it off by hand is a real pain.

The Technique

Before you load

  1. Lay a strong strap down the length of the trailer bed, hook end toward the vehicle. Keep it inside the trailer and not threaded through a mesh or cage side.
  2. Load the vegetation on top of it, front to back.

At the dump

  1. Back up to the dump's anchor point.
  2. Bring the front (hook) end of the strap up and back over the top of the load, loop it through the rear end so the strap wraps the load, and run it on to the anchor. Add a rope if it won't reach.
  3. Tie it to the anchor with a stout stick through the knot as a toggle, so the knot can't cinch tight and you can pull it free afterwards.
  4. Check that the strap wraps only the vegetation and hasn't caught on the trailer.
  5. Drive forward slowly. The strap takes up slack, then pulls the whole load off the back.
  6. Reverse a little to take the tension off and untie from the anchor.
  7. Hook that end of the strap onto the trailer and drive forward about 10 meters to pull it out from under the pile.
Safety note: A strap that catches on the trailer pulls against the trailer instead of the load. Check for it in step 6, and never thread the strap through a mesh or cage side; the creator's warning is that it "doesn't end well." Keep people clear of the strap while it's under tension.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques