Knots
Secure a Strap Tail
Dealing with the loose webbing left over once a tie-down is cinched, so it can't flap, chafe, or foul the load in transit.
3 takes from different creators
On a truck with the backup camera in the tailgate, hook the gate's support cable over the latch post so the gate stops part-way down. The camera tilts with it and puts the ball and the coupler in the same frame.
line up a trailer alone, back up to a hitch by yourself, can't see the coupler, hook up a trailer without a spotter, tailgate backup camera angle
Backing a truck onto a trailer coupler alone is tedious: reverse a foot, get out, look, get back in, move two inches, get out again. Backup cameras help, but if the backup camera looks straight back along the bumper, the coupler sits below the bottom of the frame the whole time.
With the gate held at an angle instead of flat, a tailgate-mounted camera points down at the hitch rather than out at the horizon. The ball and the coupler land in the same frame, close enough to overhead to line them up in one pass.
The camera has to be in the tailgate itself, where its angle follows the gate. Where the camera sits in the bumper or above the plate, moving the gate changes nothing.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques