Using Leveling Clips? Make Sure You Have the Right Size Trowel Notches

The Problem

A tile leveling clip has a base plate that slides under the tile edge. That plate holds the tile roughly 1/8 inch up off the substrate. If you comb the floor with a 1/4 by 1/4 inch notched trowel, the ridges are not tall enough to cross that gap. You set the tile, push it down, and the mortar barely reaches the back of it.

Lift a tile to check. The evidence is obvious: a few flattened ridge tops with bare tile between them. The clip fixed your lippage problem but has cost you most of your bond.

The Technique

Size the notch for the clip, not for the tile.

  1. Put the 1/4 by 1/4 trowel away for this job.
  2. Move up to a 1/4 by 3/8 notch for an improved bond.
  3. Go up again to a 1/2 by 1/2 for the best result. The taller ridges collapse fully under the tile and you get close to complete contact.
  4. Pull a tile early in the run to check. You want mortar across the whole back of it, not stripes.
Pro tip: The extra material costs less than the numbers suggest. Going from a 1/4 by 1/4 notch to a 1/2 by 1/2 sounds like twice the mortar, but the ridges collapse into the same thin bed — the real difference in bed thickness is about 1/16 to 1/4 inch.
Safety note: Dry thinset is a respirable silica dust, so mix it with a mask on. Wear gloves while you trowel: Portland cement burns develop slowly and without much pain at first, so you can do real damage to your hands before you notice.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques