Framing
Pull a Proud Header Flush With a Nail and Your Hammer's Claw
Levering a header or joist flush with a temporary nail as the fulcrum for the hammer claw.
@builtright_co · Instagram
Technique: Toenailing Studs
Toenailing is how you fasten studs when you can't shoot through the plate — stick-framing inside a finished opening, infilling a vault, or adding a stud to a wall that is already standing.
The nail goes in at an angle, so driving it shoves the stud sideways, away from the nail. When you set a stud right on your layout line and toenail it, the stud ends up off the line.
Two things to avoid with the gun:
A stud cut to a vault angle flexes much more at the beveled top than at the square bottom. You can move a beveled top over as much as 1/4 inch by hand before nailing, so set the position at the bottom plate and adjust at the top.
If a stud comes out a touch short and crowds the line at its short point, pull it back to the mark and send a couple of nails down through the top plate into it. That holds the position while you toenail the rest.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques