Land a Toenailed Stud on Your Layout Line by Starting It an Eighth Short

A toenail goes in at an angle, so driving it shoves the stud sideways off your line. Set the stud a heavy 1/8 inch back from the mark, shoot the first nail on the line side, and the stud moves onto the mark instead of past it.

stud moves when I nail it, toenailing studs to a plate, nail angle for toenailing, nail sprouting out the side of a stud, stud off my layout line, framing a vaulted wall

intermediate Tools: framing nailer Added Nov 1, 2026

The Problem

Toenailing is how you fasten studs when you can't shoot through the plate — stick-framing inside a finished opening, infilling a vault, or adding a stud to a wall that is already standing.

The nail goes in at an angle, so driving it shoves the stud sideways, away from the nail. When you set a stud right on your layout line and toenail it, the stud ends up off the line.

The Technique

  1. Set the stud a heavy 1/8 inch back from the layout line, on the far side from your first nail, and hold it flush at the face.
  2. Shoot the first toenail on the line side. The stud moves that eighth of an inch and lands on the mark.
  3. Infill the rest of the nails once the stud sits where you want it.
  4. Keep each toenail about 1 inch up off the plate, at roughly 45 degrees. An inch and a half is the textbook figure and rarely happens on a real wall. One inch gets full bite down into the plate without the point breaking out the back of the stud.

Two things to avoid with the gun:

  • Don't hold it level. The nail runs across the stud instead of down into the plate, and the point breaks out the far face.
  • Don't start too high up the stud. The nail skims out through the top of the plate with almost no wood either side of it — no meat on the joint, whatever the nail count is.

On a beveled top

A stud cut to a vault angle flexes much more at the beveled top than at the square bottom. You can move a beveled top over as much as 1/4 inch by hand before nailing, so set the position at the bottom plate and adjust at the top.

If a stud comes out a touch short and crowds the line at its short point, pull it back to the mark and send a couple of nails down through the top plate into it. That holds the position while you toenail the rest.

Pro tip: The 1/8 inch is a starting figure. How far the stud actually travels varies with the nail angle, the timber species, and how hard the gun drives, so watch where the first stud lands and adjust the offset for the rest of the wall.
Safety note: A toenail that breaks out the side of a stud leaves an exposed point at shin and hand height on a wall people are still working around, and it will catch drywall later. Pull it or nip it off rather than hammering it over.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques