Drill Through Blocking Inside a Wall Without Breaking Out the Drywall

The Problem

If you're running cable down an interior wall that has blocking partway down, you have to drill through the blocking from the top plate with a drill bit on extensions, out of sight. If the bit drifts toward the face of the wall, it breaks out through the drywall.

The Technique

  1. Drill three holes through the top plate into the same cavity: one for the drill bit, one to look down, and one to shine a light through. He wears a headlamp and aims it down the third hole.
  2. Tape the bit to its extensions at each joint. He says a joint left untaped comes apart and you lose the bit down the wall.
  3. Feed the bit down to the blocking. Look down the viewing hole and line the bit up on the center of the blocking.
  4. Drill through the center of the blocking, watching it the whole way so the bit stays clear of the drywall.
  5. Pull the bit out, push the fish tape down the bit's hole through the top plate and blocking, and watch it through the viewing hole to steer it through the blocking.

Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques