Wiring
Light a Wall Cavity While Fishing Wire
A second hole in the top plate for a flashlight, turning a blind fish into one you can watch.
2 takes from different creators
Stripping the outer jacket back off the cable end leaves the conductors loose enough to turn the right angle where two drilled holes meet inside a stud. They drop into the second hole as they pass it, where you catch them with needle-nose pliers and pull the cable through.
romex won't go round the corner, pull cable through a stud at 90 degrees, cable stuck in a stud hole, wire a corner stud bay, stiff cable won't bend in a stud
Where a run has to change direction inside framing, the two drilled holes meet at a right angle inside the stud or the top plate. When you push the cable into the first hole it hits the far side of the timber and stops: there is no radius for it to follow, and nothing to grab from the other side because the end is still buried.
The jacket holds the conductors flat and side by side, which makes it harder to turn a sharp corner. With the jacket off, each conductor bends on its own. The stripped end also gives the pliers something to bite that is narrower than the cable.
Electrical, plumbing, and structural work may be regulated where you live — check local code before you start, and note that a permit may be required. More in our disclaimer.
DIYsolvr helps you find the best DIY videos. Browse all 609 techniques