Shim a Prehung Door Jamb Plumb With the Door Off

The Problem

A prehung door arrives as one unit, and the door slab is the heaviest part of it. You shim in the gap between the jamb and the rough opening, which is where the slab hangs: it blocks the hinge side and swings whenever you lean on the frame.

Drywallers leave the opening dirty too — mud squeezed out at the corners, a ridge of compound along the stud, screws proud of the face. Any of it holds the jamb off the framing, so a frame can show as plumb but still bind.

The Technique

  1. Clean the rough opening first. Knock off mud ridges, pull anything proud, and sweep the floor so the jamb legs sit on wood rather than on debris.
  2. Pop the pins out of the hinges and lift the door out. Lean it somewhere it can't fall.
  3. Set the frame in the opening and wedge the hinge jamb with a pair of shims from each side, so they tighten against each other instead of crushing in one direction.
  4. Put the level on the hinge jamb and adjust the shims until it reads plumb across the full height, then tack a nail or screw through the jamb and shim to hold it.
  5. Hang the door back on its hinges and look at the gap around it.

That is the hinge jamb set. The latch side and the head get shimmed afterwards the way you always do them — this method is about getting clear access to the jamb that has to be right first.

Chasing the Reveal

An uneven reveal along the top usually traces back to the hinge side. A single shim driven in above the top hinge can pull that corner over enough to even it out.

Work one shim at a time and shut the door after each. At this point you are reading the gap, not the level.

Pro tip: Taking the door off also makes a prehung door a one-person job. Without the slab, the frame is light enough to lift, square and hold with one hand while you set a shim with the other.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques