Hitch a Trailer Alone by Angling Your Tailgate

The Problem

Backing a truck onto a trailer coupler alone is tedious: reverse a foot, get out, look, get back in, move two inches, get out again. Backup cameras help, but if the backup camera looks straight back along the bumper, the coupler sits below the bottom of the frame the whole time.

The Technique

  1. Lower the tailgate partway.
  2. Secure its support cable on the latch so the gate stops part-way down instead of dropping flat.
  3. Get in and use the camera as normal.

With the gate held at an angle instead of flat, a tailgate-mounted camera points down at the hitch rather than out at the horizon. The ball and the coupler land in the same frame, close enough to overhead to line them up in one pass.

Which Trucks This Works On

The camera has to be in the tailgate itself, where its angle follows the gate. Where the camera sits in the bumper or above the plate, moving the gate changes nothing.

Safety note: Check the gate is captive on the latch before you move the truck, and un-rig it once the trailer is on rather than driving with the gate held at an angle. The creator's own caution is to make sure the setup works safely on your particular truck before trying it.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques