Close a Kinked Snap-Lock Duct Seam by Lifting While You Tap

The Problem

If a length of snap-lock duct got bent in delivery or in the truck, the seam won't go together, and prying the lock open with a flathead to work it in is slow.

The Technique

  1. Start the seam where it isn't kinked and snap that part together.
  2. At the kink, bend the metal up and away from the seam by hand.
  3. Keep lifting and tap along the seam with a hammer at the same time.
  4. Work along the kink this way. The seam closes as you go.

Smacking the kink flat with the hammer alone makes it worse. Lifting while you tap takes the bend out as the lock seats.

Safety note: Cut duct edges are sharp. Wear gloves when you are bending sheet metal by hand.

DIYsolvr helps you find the best DIY videos. Browse all 609 techniques