The Problem
If you don't have — or can't find — the janky rip fence that came with your circular saw, you don't have to make the cut by hand or take the piece to your table saw.
The Technique
A stair gauge — the small clamping stop that fixes to a framing square when you're laying out stringers — does the same job as the factory fence for narrow rips.
- Clamp the gauge to the edge of the saw shoe, on the side away from the blade, with its thumbscrew.
- Set it so the distance from the blade to the gauge face is your rip width. Cut a test piece if the width has to be exact.
- Run the cut with the gauge face held against the edge of the board. It rides the edge the way the factory fence does.
The limit is geometric: the fence can only sit at the edge of the shoe, so the widest rip you can make is roughly the distance from the blade to the outside of the shoe. That's a few inches. For anything wider you're back to a straightedge.
Pro tip: The tall pattern of stair gauge is the better one here — a taller face means more bearing surface against the board edge, so the saw is less able to tip away mid-cut. A standard gauge works, but there's less of it touching the work, and you'll feel it on a board that isn't perfectly flat.
Safety note: Narrow rips put your guide hand close to the blade and leave an offcut too thin to hold safely. Clamp the workpiece rather than holding it, keep the offcut side free so it can't pinch the blade, and check the thumbscrew is tight before every cut — a gauge that slips mid-rip takes the saw with it. If you are tempted to add a second gauge for a longer reference, set both faces dead parallel to the blade first: two references that disagree pinch the shoe between them and bind the cut, which is worse than the single one you started with.